WORKING PRINCIPLE OF A LIGHTNING PROTECTION VALVE

Chống sét van là một thiết bị chống sét hoàn hảo nhất dùng để bảo vệ cho trạm biến áp, trạm phân phối và các máy điện khác.

The structure of a lightning arrester valve consists of two parts:
– On the outside is an insulating ceramic or plastic tube, the shape, and size of which are determined by the rated voltage level. 
– The inside of the tube contains two main elements, the discharge gap and the nonlinear resistance

— The discharge gap consists of multiple pairs of gap couplings in series. Each pair of openings is made by two thin copper plates. In the middle is a mica pad or insulating board about 1mm thick to create a discharge gap. Each arrester valve has a number of pairs of discharge gaps depending on the design manufacturer.
— Nonlinear resistors consisting of circular, cylindrical plates connected in series. Nonlinear resistance can be Vilit, Tirit, or Tirit or ZnO… (usually Vilit)

Nguyên lý hoạt động của chống sét van chủ yếu phụ thuộc vào tính chất của điện trở Vilit. Khi điện áp đặt lên Vilit tăng cao thì giá trị điện trở của nó giảm và ngược lại khi điện áp giảm xuống thì điện trở sẽ tăng lên nhanh chóng.

When there is an overvoltage applied to the lightning arrester, the resistance of the lightning arrester is quickly lowered to facilitate the removal of all lightning waves through it to the ground. The resistance of the surge arrester is greatly increased, terminating the continuity line at the most appropriate time.

At the same time, during a lightning discharge, the residual voltage on the arrester valve is also small, this will ensure the safety of the protected equipment.

Chống sét van có đặc tính tác động tương đối bằng phẳng nên chống sét van không những có tác dụng hạ thấp biên độ mà còn làm giảm độ dốc của sóng sét. Vì thế, nó có thể bảo vệ chống được hiện tượng xuyên kích giữa các vòng dây trong cùng một pha của các máy điện.

Vilit resistors are susceptible to moisture, which will change electrical characteristics and make the valve lightning arrester ineffective, so it is necessary to take measures against moisture for Vilit resistors.